Set Up a Basic Wireless (Wi-Fi) Network Connection

1. Power-cycle ALL network equipment.
   Turn off (unplug) ALL of your network equipment, including any wireless access points, routers, Voice Over IP (VOIP) modems, and broadband modems for two (2) full minutes. 
   
   
2. Confirm that your internet connection is enabled. 
   In the XMB™ home menu, go to  (Settings) > [Network Settings ] > [Internet Connection] and select [Enabled].
   
   
    
   

Scroll down to [Internet Connection Settings] and press the   

1. When prompted, "Do you want to continue?" select [Yes].
   On the next screen, select [Wireless] as your connection method and press the  button.
   
   
2. Pick "Scan" and press the  button.
   
   
   
3. From the list, pick your SSID and press the  button.
   
   
   
4. On the next screen, press right on the directional pad to continue - do NOT press the button to [Edit].
   
   
5. Pick your WLAN Security Setting (either WEP or WPA-PSK/WPA2-PSK).
   If none, pick [None] (and skip the next step).
   Press the  button.
   
   
   
6. If you selected a Security Setting, enter your security key with the keyboard.
   Press the [Start] button to exit the onscreen keyboard.
   Press right on the directional pad to proceed to the next screen.
   
   
   
7. The system will check your network configuration settings and display the information.
   Press the  button to save these settings.
   
   
   
8. Test the connection on the next screen.  Press the  button to start the test. 
   
   
   
9. When the test is complete (usually less than a minute), it will display the results ("Succeeded" or "Failed"). 
   If you have successfully connected to your network, congratulations, you have completed the network setup process.